|Affected by Gravity||No|
In order to construct a Dynamic Tank, first create a frame out of Dynamic Tank blocks. This frame can be between three and eighteen blocks. It does not need to be square. Once the frame is constructed the sides must be filled in using a combination of Dynamic Tank blocks, Dynamic Glass blocks and Dynamic Valves. Once the structure is complete it will flash with Redstone particles.
Once the structure is complete fluids can be pumped in or out from the Dynamic Valves. The level of fluid in the tank can be seen through the Dynamic Glass or in the interface of the Dynamic Tank.
The amount of fluids that can be stored in the tank are calculated as
length x width x height x 16,000mB.
The Dynamic Tank's interface is shown below.
The different areas of the interface are:
- This shows the level of fluid in the tank. Hovering over it will display the amound of mB stored.
- This shows the volume of the tank in blocks. Each block can store 16 buckets of fluid.
- This shows the type of liquid and the amound stored.
- An empty fluid storage item placed in the top slot will be filled and placed in the bottom slot.